Repairman-Jack
n3wb
Previous owner of our house left his 16 camera Geovision system. I've bee slowly purchasing IP cameras to switch over from the old analog system. The main PC that holds a DVR card for 8 of the cameras and the Software to watch the PC holding the other 8 in the shop has enough HP to run BI so I installed Blue Iris 5.x yesterday. I can add my IP cameras no issue but until I've switched over fully to IP on the house I'd like to add the 4 analog on the DVR card.
Has anyone had any success adding a Geovision card to Blue Iris? If so can you share what settings you used?
I've toyed around this morning and I keep getting "Error:8000274D(refused; check IP address and port)0 This error message was not real helpful.
Has anyone had any success adding a Geovision card to Blue Iris? If so can you share what settings you used?
I've toyed around this morning and I keep getting "Error:8000274D(refused; check IP address and port)0 This error message was not real helpful.