Hi all, new to this forum. Have my 1st question. I just had a Flir 8 channel 6 camera NVR system installed (DN308P2E6). I just purchased two additional cameras so all 8 channels will be used. The cameras are the same model# that came with my system. My problem is I installed the new cameras and verified that the cables were good but I can't get them up and running. I was told by a Flir salesman that my system would automatically recognize them but that's not the case. I've tried doing a device search, they show up but must be configured I assume because the port, MAC address, etc. are different than the original 6. Can anyone give me an idea of how to set them up? Thanks.