DAHUA DH-SD59225U-HNI and clone got wet...can they be repaired?

[Optimus Prime]

Hey gang. I've got a DAHUA DH-SD59225U-HNI and a clone. Tornado season occurred, and with the pouring rain, I learned I did not have a good seal on the mounting box and did not drill a drain hole in the bottom. The ethernet connections got wet.

Both cameras are none functional. One accepts power but does not transmit data. The other is not transmitting data, not power.

Before I try just re-crimping the ends, does anyone have a patch/wire diagram for the ethernet ends? And if it is just not burnt ends, are these components repairable at a reasonable cost vs buying new?

And if anyone can affect repairs and you are in DFW, I'm willing to pay a little. Each camera cost me $450 and $250, so there's also the cost vs buy again dilemma.

Thanks for your time.

 

[EMPIRETECANDY]

If the board broken, no one can fix up it, only have to send to dahua warranty center, the cost will be bit high if change the whole board, even can buy a new camera.

 

[Optimus Prime]

@EMPIRETECANDY It's the one I bought from you. It would not be worth shipping it to a warranty center. Would you have a pinout diagram so I can try re-crimping the cable? I might get lucky and it just be the end of the cable is burnt.

 

[wittaj]

Lot's of threads showing the Dahua pinout.

But you have an advantage that you have the pigtail so you can match it up even without a pinout.

Before cutting it off, see if the camera powers with the wall wart?

IPC-T5442TM color code/pinout for the Ethernet

I have a IPC-T5442TM that I need to replace the Ethernet plug does anyone have a colour code for the wires?

ipcamtalk.com

IPC-T5442T-ZE PoE Pinout Tip - For Broken Connector RJ45

I just wanted to make a post to help others in the future. Recently I damaged the end of my connector on IPC-T5442T-ZE Black Camera. Dahua IPC-T5442T-ZE uses the T568A pin out. Not the B more prevalent method here is US. Originally I had it wired like image IMG_9537.jpg (B). However camera...

ipcamtalk.com

T568A vs T568B pinout for cameras

Has anyone experienced issues with using the T568A pinout and getting Amcrest cameras to work? I have some of the empire tech rebranded Dahaus and they have worked perfectly with my Cat 5e cable that is terminated with T568A pinout on both ends. When I hook up the Amcrest ip5m-t1179ew-36mm I...

ipcamtalk.com

**FIXED** Complete newby, damage to RJ45 connector!

So, I’m new to all of this, I am pretty tech savvy for the most part but I am stumped. I have a 8ch 1080p SANNCE NVR wireless system, came with 4 cameras paired to NVR, i was considering changing interface so I was changing the camera ip’s to my network’s gateway, well silly me conflicted the...

ipcamtalk.com

 

[ludshed]

And don’t forget to unplug cables at poe port before recrimping