I rebooted my camera from the web interface, and now it won't turn on at all. There's no click, and the LEDs on the board stay dark. The IR LEDs don't respond to my covering the lens. Holding the reset switch down doesn't have any effect. It doesn't connect via wi-fi, or even show up in the ARP table when I connect it to my switch. I get the same (lack of) results whether I power it through the barrel plug or PoE.
The only signs of life whatsoever are that my non-contact voltage tester shows power reaching the board, and my switch shows a physical connection when I plug it in. So I guess I've ruled out a bad cable. :/
Is there any way to revive it, or did an electrical component somehow burn out during the software reboot?
The only signs of life whatsoever are that my non-contact voltage tester shows power reaching the board, and my switch shows a physical connection when I plug it in. So I guess I've ruled out a bad cable. :/
Is there any way to revive it, or did an electrical component somehow burn out during the software reboot?