DAHUA NVR 4216-8P HOW TO RESET WITH FACTORY SETTINGS

V

Vincent Bariset Goldstein

n3wb
Oct 26, 2018
6
1
France
Hello,

Somebody could help me to reset my NVR Dahua 1642 8p to the factory
Settings.

I loose all my passwords for all accounts
Admin
888888
User
And default ( Hidden account)

Thank you...because i am lost !
 
You mention another type (1642) in your message/subject line.

I suggest you install Configtool (under Dahua Toolbox), let it find the NVR and hopefully you can trigger password reset from there.

Good luck!
CC
 
Thank you for your answer
My mistake i was talking about an nvr
DAHUA 4216-8p for 8 poe.

I installed already yesterday the config tool firmware but
I am not able to detect my nvr in local network.
I use the generic ip adress 192.168.1.108
And nothing !
I turn off all the fire walls
Please what do you think about this ?
Best regards
 
Vincent Bariset Goldstein said:
Thank you for your answer
My mistake i was talking about an nvr
DAHUA 4216-8p for 8 poe.

I installed already yesterday the config tool firmware but
I am not able to detect my nvr in local network.
I use the generic ip adress 192.168.1.108
And nothing !
I turn off all the fire walls
Please what do you think about this ?
Best regards
Click to expand...

And did you put your pc in the same network as the NVR (eg 192.168.1.250) and try to ping it? If that works, try to http://192.168.1.108 into it.
 
Vincent Bariset Goldstein said:
Hmmm, the problem is coming from my network configuration
As you says....
I ping the nvr via my internet box.....but no answers !

I check the problem now, and give u some update later
Thanks
Click to expand...

Tip of the day: bypass all your network gear: plug in an ethernet cable FROM your laptop TO the NVR "en direct", put in 192.168.1.250 with subnet mask 255.255.255.0 in your ETHERNET card (not your wifi - best to disable that one temporary). If ping works: you're set for Configtool reset.

Bonne chance!
CC
 
You must log in or register to reply here.
Top Bottom