Disable Intrusion Detection when using PTZ camera controls

[joey54]

I have a DS-7608NI-E2/8P NVR and a DS-2DE3304W-DE PTZ IP camera.

I've configured the PTZ camera for Intrusion Detection and to send an alarm if something enters the defined area.
Sometimes I want to use the PTZ features to look around and zoom into certain areas but I do not want the intrusion detection alarm to be triggered (which keeps happening). Is there a way to disable intrusion detection automatically whenever I'm just "looking around"? I only want Intrusion Detection enabled when the camera is on preset 1.

My Firmware:
DS-7608NI-E2/8P v3.4.92 build 170228
DS-2DE3304W-DE v5.4.8 build 170210

thx

 

[lgRich]

try this... Check "Suspend motion detection"

 

[joey54]

Where is this screen capture from? I have never seen these options? Is this applicable to Hikvision NVR / Camera?
Thx

 

[fenderman]

Where is this screen capture from? I have never seen these options? Is this applicable to Hikvision NVR / Camera?
Thx

no, that is from blue iris, which you are not using...

 

[joey54]

any way to do this using the Hikvision software?