DS-2DE4220-AE

[puppenau]

What i can do whit this problems is my device bricked
Is there any easy way for dummy

encoding versio v5.0 150908 after i update 5.4.71 it work well litle time but then trying conficure my new hikvision nvr ...
Error browser login page. language mismatches
Firmware Version*:updated IPD_R0_EN_STD_V5.4.71_Build170407
encoding versio

Complete Device Serial Number*: DS-2DE4220-AE20160416CCCH593190860

firmware language mismatch: /home/webLib

SADP tool working well i can change ip adress etc. But camera stay offline

 

[alastairstevenson]

Complete Device Serial Number*: DS-2DE4220-AE20160416CCCH593190860

That suggests it is a Chinese camera, and if so, applying the EN firmware would give the 'language mismatch' error you have seen.

If the camera is an R0 series camera - and it does seem to be from the naming of the firmware for it - you should be able to convert it to English and recover it and fully update it with the brickfixV2 method here :
R0 / DS-2CD2x32 BrickfixV2 brick recovery and full upgrade tool - enhanced.

 

[puppenau]

That suggests it is a Chinese camera, and if so, applying the EN firmware would give the 'language mismatch' error you have seen.

If the camera is an R0 series camera - and it does seem to be from the naming of the firmware for it - you should be able to convert it to English and recover it and fully update it with the brickfixV2 method here :
R0 / DS-2CD2x32 BrickfixV2 brick recovery and full upgrade tool - enhanced.

I didnt get work that brickfixV2 method . This is DS series camera . I get seen videos via hikvision TOOL v1.2.1.1->remote cònfiguration->event->motion detection and theres showing time/date china language. So still cant use camera, ivms4200 not connect camera. Is there any other method what i can try change that language error

 

[alastairstevenson]

I didnt get work that brickfixV2 method .

At what point did the method fail or not work?

 

[puppenau]

At what point did the method fail or not work?

tftpd32.exe work, but upgrading process won't start not doing anything.
status messages in the tftp updater is blank
My camera factory default ip is 192.168.1.64 port8000 software 5.4.71
Username admin and password is bit different than usually 1234567a

 

[alastairstevenson]

status messages in the tftp updater is blank

This is the Hikvision tftp updater tool?
What IP address did it say 'initiallised' at? It should show 192.0.0.128 or it will not operate.

tftpd32.exe work, but upgrading process won't start not doing anything.

That's for Stage2&3 of the brickfixV2 method only - a normal tftp server.

Is there any other method what i can try change that language error

Suggestion:
See if the Stage1 part of the brickfixV2 method can be started by using the Batch Configuration Tool to apply the brickfixV2CN or EN initial firmware.
Download | Tools - Hikvision
If that works - you can then proceed with Stage2&3

 

[puppenau]

I think this is too hard for my skills. I need lot of time and think whit this. Maybe i need remote support