Err_Connection_Refused

dentalan

n3wb
Joined
Oct 17, 2019
Messages
4
Reaction score
0
Location
Greece
My cheap IP camera (a board from ebay) was perfect for some years now. Suddenly I lost connection. When trying to connect to port 80 (GUI) it replies "ERR_CONNECTION_REFUSED". I can ping the camera and I can see the network leds flashing, but I cannot connect to any port. I think the only cjance to make it work again is to make a hardware reset, but I do not how.
Any ideas?
 

Attachments

TonyR

IPCT Contributor
Joined
Jul 15, 2014
Messages
16,443
Reaction score
38,159
Location
Alabama
Any relevant board circuitry to be shown at top where image got cut off?
Also from straight on if possible so as to not hide possible reset pads, etc. behind plugs.
 

dentalan

n3wb
Joined
Oct 17, 2019
Messages
4
Reaction score
0
Location
Greece
I hope the images are better
I beleive that the reset pin is either pin A (on the power in header) or pin B (on the audio in out header)
I am not sure though about the proccedure
I tried to short circuit pin B with ground on board startup for 5 to 30 secs. Nothing was reset
 

Attachments

Top