Geovision camera connecting

[Nejc]

Hello, I can't seem to figure out how to add Geovision cameras to BlueIris. Cameras are Foscam GV-CB120. Any suggestions? I'm using default username/password which is admin, and default 10000 port.

Thank you.

 

[fenderman]

Hello, I can't seem to figure out how to add Geovision cameras to BlueIris. Cameras are Foscam GV-CB120. Any suggestions? I'm using default username/password which is admin, and default 10000 port.

Thank you.

How to add camera to BI that is not in the drop down list

 

[dryfly]

This worked for a GV 120 FD for me:

Log into your GV web interface for the camera, go to Events and Alerts>RTSP and be sure you have RTSP enabled (activate link) it should show port 8554 by default. make the change and save that.

Now pull up BI and add a camera. Select the Geovision Make and then you may have to try both model options to see what works for you. Make sure RTSP port shows 8554.

Under your GV web interface... be sure you adjust your FPS as the default is 30fps. You will need to select "custom" as your connection speed to modify the FPS, if not it will be grayed.

 

[Nejc]

Hey, just got it to work 30 minutes before you replied. I used Generis as make.
I've also set same RSTP and ONVIF ports on all camerac, 1 had TPC disabled, firmware were not the same.. A lot of struggle but got it to work after a couple of hours. Thanks anyway!