Before I start salvaging this old NVR for parts I just thought I'd ask if anyone has any other suggestions on how to fix it. The problem it developed is that it will not save ANYTHING. It's like the EEPROM, or whatever is used to save settings, is dead. When I hook it up to a monitor and turn it on, I eventually get the first time setup. I can go through all the steps of entering passwords, security questions, network config, etc. and apply/save all of it. I can add cameras, etc and watch them on the monitor. However, any reboot and it is all gone. Upon reboot I am greeted with the initialization routine again. It is running old firmware (V 3.100 something), and I have tried a couple of times to upgrade. It always fails.
So does anyone have any (constructive please) suggestions on how to fix it? If I could get it running again, it could make a good backup recorder.
Thanks,
Wayne
So does anyone have any (constructive please) suggestions on how to fix it? If I could get it running again, it could make a good backup recorder.
Thanks,
Wayne