Hello all,
Have just joined this forum, and am pleased to be here. I have been going mad trying to resolve a problem with my setup. I will explain. I have a two camera setup, witha third to be added later. One of the cameras is a Escam QD500 Snail, and the other two cameras are Sricam AP003. Initially i had only the Esam running, with its proprietry software and it worked well, but seeing that i was going to add more, and got a bit of a deal on the two SRIcam models, i realised i needed some generic software to run them all.
When setting up the Escam in Genius Vision, all went well and everything works fine. I was pleased given my very limited knowlage of IP cameras. However, trying ro set up the Sricam is a different matter. The only way i have managed to get a picture from it is ti use the Finder tool that comes bundled with the camera. As yet, nothig ive tried gets Genius Vision to see it. Should i be using a different piece of software?
I will add the second Sricam into my setup as soon as i manage, if ever, to get this one working. I am not using wireless on any of my cameras, all are wired to my pc via a hub. I do not wish to view them over the internet or via smartphone, only via software on my pc!
Any help would be greatly appriciated. This is driving me nuts!!!
Regards
Phil
Have just joined this forum, and am pleased to be here. I have been going mad trying to resolve a problem with my setup. I will explain. I have a two camera setup, witha third to be added later. One of the cameras is a Escam QD500 Snail, and the other two cameras are Sricam AP003. Initially i had only the Esam running, with its proprietry software and it worked well, but seeing that i was going to add more, and got a bit of a deal on the two SRIcam models, i realised i needed some generic software to run them all.
When setting up the Escam in Genius Vision, all went well and everything works fine. I was pleased given my very limited knowlage of IP cameras. However, trying ro set up the Sricam is a different matter. The only way i have managed to get a picture from it is ti use the Finder tool that comes bundled with the camera. As yet, nothig ive tried gets Genius Vision to see it. Should i be using a different piece of software?
I will add the second Sricam into my setup as soon as i manage, if ever, to get this one working. I am not using wireless on any of my cameras, all are wired to my pc via a hub. I do not wish to view them over the internet or via smartphone, only via software on my pc!
Any help would be greatly appriciated. This is driving me nuts!!!
Regards
Phil