Hikvision 2MP intercom DS-KD8003-IME1(B) vs non B

tchall

tchall

n3wb
Jun 23, 2024
3
0
brisbane
Hi
does anyone know the difference between
DS-KD8003-IME1(B)
vs
DS-KD8003-IME1 --- NO B

and is one version 1 ? or are they both version 2?
many thanks
 
I am not so sure, i thought B was for black but I am not so sure now as :
it seems that there are differences for example

DS-KD8003-IME1(B) FOV: Horizontal, 146°, Vertical, 82°
DS-KD8003-IME1 FOV: Horizontal, 180°, Vertical, 96°


does anyone have any knowledge on it
 
  • Like
Reactions: duplo
Its same as in cameras or NVRs, having B,C,D tag

Thats hardware revision. B one will get newest releases while non B is EOL

The villa stations like 8113-wme1 already have C revision
 
B have different cmos (older had 180° fisheye, new ones 146° V)
B have 12V DC output (in non-B with poe it was working, but wasnt specified like should not be used)
B have already newer firmware
In my experience with Hikvision never get older ones unless you are 100% sure you need older one (like in 2wire intercoms that are not compatbile with new Y versions etc).
 
sensey3 said:
B have different cmos (older had 180° fisheye, new ones 146° V)
B have 12V DC output (in non-B with poe it was working, but wasnt specified like should not be used)
B have already newer firmware
In my experience with Hikvision never get older ones unless you are 100% sure you need older one (like in 2wire intercoms that are not compatbile with new Y versions etc).
Click to expand...
Nice catch regarding FOV

Regarding output, on older version it worked rly good, on B version varry between 6 to 12V barely 0.5Amps sometimes itll work sometimes wont

Hence.5 amps AC bolts wont work as they draw up to 2amps of DC when unlocking
 
trempa92 said:
Nice catch regarding FOV

Regarding output, on older version it worked rly good, on B version varry between 6 to 12V barely 0.5Amps sometimes itll work sometimes wont

Hence.5 amps AC bolts wont work as they draw up to 2amps of DC when unlocking
Click to expand...
Better to use low power locks that draw about 250-300mA, and even better just install additional power cable or 2x lan and use separate circuit/psu for lock.
Dc out can also be used to power some card readers like DS-K1107AM, or illumination in the exit button, so not that useless.
 
sensey3 said:
Better to use low power locks that draw about 250-300mA, and even better just install additional power cable or 2x lan and use separate circuit/psu for lock.
Dc out can also be used to power some card readers like DS-K1107AM, or illumination in the exit button, so not that useless.
Click to expand...
Or just 1 Cat5 or 6 and crimp out 1,2,3,6 which will give 100mbit network + poe and leave 4,5,7,8 for 12V PS in.
 
You must log in or register to reply here.
Top Bottom