Hikvision DS-2CD2132F-IS FPS Low

[jaredtizzle]

I've done some searching, and I can't seem to figure out why my dome camera is stuck ~1-2fps

Below are my settings

Firmware Version	V5.2.5 build 141201
Encoding Version	V5.0 build 140714

The cameras are connected to a Cisco 2960S through an 8 port POE injector. (All Cat5E)
The switchports are hardset to 100/full. The runs are a max on 150ft.
Connection from my switch to BI pc is Cat6 running at 1000/full.






Thank you for any help you can provide!


Edit:
I should add, I'm seeing a large quantity of errors on the port for this camera
Port Align-Err FCS-Err Xmit-Err Rcv-Err UnderSize
Fa0/1 0 37 0 37 0
Fa0/2 0 567 0 567 0
Fa0/3 0 101486 0 101770 0
Fa0/4 0 0 0 0 0

 

[fenderman]

@jaredtizzle Welcome to the forum. What are you camera exposure settings?

 

[jaredtizzle]

@fenderman Thanks! Lots of good info here that helped me get started!

Exposure Settings below!

 

[fenderman]

@fenderman Thanks! Lots of good info here that helped me get started!

Exposure Settings below!
View attachment 9415

No problem. How does the frame rate look when connected via browser or vlc?

 

[jaredtizzle]

It looks ok, Much better than in blue iris. I don't know if there is a way to directly view frame rate in browser. I can still notice occasional hangups though.

My other camera (Cheap 30$ Hosafe) has 30fps in BI and no stutter ever.

 

[fenderman]

It looks ok, Much better than in blue iris. I don't know if there is a way to directly view frame rate in browser. I can still notice occasional hangups though.

My other camera (Cheap 30$ Hosafe) has 30fps in BI and no stutter ever.

Disable all other cameras in BI and test. The demo mode seems to cut fps..I have seen this on a few installs, as soon as I enter the key the frame rate goes up.

 

[jaredtizzle]

Even using ONVIF, I get "No Signal" 5-6 times a minute. I'm wondering if i possibly have a bad termination on that cable...

 

[fenderman]

Even using ONVIF, I get "No Signal" 5-6 times a minute. I'm wondering if i possibly have a bad termination on that cable...

That is very probable. What kind of cable are you using? brand? Copper or copper clad aluminium (CCA) did you wire using 568 standards?

 

[jaredtizzle]

Hitachi UTP Cat5E, solid copper. Terminated to T568B on both ends.

 

[fenderman]

Hitachi UTP Cat5E, solid copper. Terminated to T568B on both ends.

if its easy to reach, take it down and test with a short cable.

 

[jaredtizzle]

I seem to be getting ~1900kbps with a VLC stream. Man, these things are tough. lol

 

[Masejoer]

I haven't wired up my house with CAT6 yet and my server is inside, so I setup two wireless routers to act as a dedicated bridge between garage and house. When the connection would get weaker, I'd see the same behavior you're describing - not enough frames reaching BI. It was an issue with connectivity between camera and server.

I'd also recommend checking the cable as suggested above.

 

[jaredtizzle]

I've gotten up to 25 FPS, I changed a few settings in BI.

 

[jaredtizzle]

Odd situation... When I add a 2nd Hikvision Camera (DS-2CD2632F-IS), both cameras have extreme frame drop and almost always lose connectivity. I've ruled out the POE device by connecting the new camera to a separate POE injector. I also re-ran the cable for the original dome camera. Any ideas?

 

[jaredtizzle]

It seems like there is interference... Even in this screenshot you can see my Front Door camera show up where the front corner should be..I'd rather not sit in wireshark for 3 hours, anybody have any clue what is happening?
IP Address of the dome camera is 192.168.1.11, the new bullet is 192.168.1.12

 

[fenderman]

uncheck use rtp/udp ports

 

[jaredtizzle]

Thats how i got my FPS up ffended:

maximum effort

 

[fenderman]

Thats how i got my FPS up ffended:

maximum effort

disable it...you have something else going on..reset you cameras and delete the cams in blue iris and start over.

 

[jaredtizzle]

I've done that twice already. Disabled that setting, frame rates are low again on the camera with that disabled.