Hikvision NVR 7608, camera set-up issues?

[Kaneteg]

I have a 7608 with only 1 camera so far. When I look in the camera set-up menu I see the same camera's IP-adress in the bottom as camera D1 on top.
In my Hik-connect app in my mobile I see a camera 0 that is not started.
See the 2 pictures below from my NVR monitor and my mobile.
Any tips on what to do?

 

[alastairstevenson]

When I look in the camera set-up menu I see the same camera's IP-adress in the bottom as camera D1 on top.

That's where it offers any 'found' cameras for you to 'add' to the NVR using the + button.

 

[Kaneteg]

I tried with the +, "No more IP cameras allowed" was the message.
The camera is not connected to the NVR directly, it's on my home network.

 

[alastairstevenson]

The camera is not connected to the NVR directly, it's on my home network.

OK, so here's what you need to do.

If not already done so, use SADP to assign the camera an IP address in the LAN range, assuming the NVR LAN interface is also on that range of addresses.
This is via the NVR web GUI - similar steps are possible via the NVR VGA/HDMI interface :
Under Camera Configuration, select an unused NVR PoE channel, and using the 'Modify' button, change mode to manual, change the IP address to match what you set the camera to.
Ensure the camera password is valid, and assuming a Hikvision camera, the Protocol selected is Hikvision, the port is 80.
Click OK, and after a few seconds check in Live View.

 

[Kaneteg]

Thanks, I changed the IP adress of the camera to 192.168.1.xxx (from 192.168.254.2 that was set by the NVR earlier) and changed to D3 in the camera menu. So now it disappeared in the bottom of the camera list.
But I still have a camera 0 in the mobile app.......
Shall I do a factory reset of the system and uninstall the mobile app and start from the beginning?

 

[alastairstevenson]

Oops - I meant to say port=8000 not 80

Does the camera show in Live View?

 

[Kaneteg]

Yes, I see it in live view and in my mobile.