spammenotinoz
Getting comfortable
So same version version as all of us, yes older build date.
Different build dates though, yours is older. Perhaps you had a pre-release version and they pulled the feature before official release.
IPC-T5442T-ZE dual IR - electrical tape?
- Thread starter Firenor
- Start date
-
- Tags
- dahua ipc-t5442t-ze
Ofcourse I replied like I did when I was not aware of this firmware update with this new options. Thanks a thousand mate! I will look into updating the firmware this evening and try this rather new option out. This will probably solve my problems, big cheers!!
To throw in a comment from me, I have two 5442s from Andy. Both have the 2020-12-03 firmware. The bullet has two sliders but the turret only has one. I though this was a commonly understood limitation of the turret construction for some reason. Or am I wrong (yet again)?
handinpalm
Getting comfortable
I have the latest 12-03-20 update loaded and do not have the 2 IR LED selection under Manual. Just in case, I went back to Default setting and looked at the Manual IR setting, before I imported my settings. Still do not have 2 IR LED setting, just 1 scale for Manual. Evidently there was an interm release around 10-19-20 that had the 2 LED selection. I find the Auto (Smart IR) capability is still Not fully functional because of the wash out for close targets. Maybe that is a clue, the term "Smart IR" is not used anymore. I still use the manual IR setting set to around 15 to eliminate the wash out. I believe that Andy stated there will be another update this year. . . .
Same here. I just did the upgrade and now have version V2.800.15OG004.0.R, Build Date: 2020-12-03 and I can also confirm that it does not have option for dual led control. Too bad!
Is it possible to downgrade to the version that does have this setting? Anyone has it?
If you’re saying the interim release 10-19-20 5442 turret had the 2 IR selection handinpalm, I’d say this was a mistake. Its surface area is smaller than the bullet and therefore able to dissipate less heat. The power supply has a correspondingly lower rating. Overdriving the LEDs will undoubtedly cause premature failure. Take care with the slider settings! (or play safe and update the firmware)
