Lorex NVR issue

NorthBendDave

NorthBendDave

Pulling my weight
May 27, 2021
127
159
Washington, USA
My Lorex suddenly changed from recording all MD (green bar marked with yellow marks) on each camera view, to only show all camera's MD indications on cam view 1. I discovered this watching playback in sync view. Any idea how to get each camera to show their own MD?

I have 7 cameras connected to it.
 
NorthBendDave said:
My Lorex suddenly changed from recording all MD (green bar marked with yellow marks) on each camera view, to only show all camera's MD indications on cam view 1. I discovered this watching playback in sync view. Any idea how to get each camera to show their own MD?

I have 7 cameras connected to it.
Click to expand...

Hi @NorthBendDave

Wondering if the NVR rebooted and reset something, or if it got a firmware update.
 
  • Like
Reactions: Flintstone61
Could have rebooted. I know it was beeping last week, has an issue with #1 drive(has a red exclamation mark on drive status). Glad I installed a second drive a couple of months ago.
 
  • Like
Reactions: Flintstone61 and mat200
No, it isn't fixed yet. I did reformat the drive with the error, but the motion detect is all logged onto cam 1
 
I have discovered I need to set MD and zones from the NVR, not the network. I also set each MD to the entire camera view, except for 1 overview camera. I'll try to set the zones smaller, but one cam at a time.
 
You must log in or register to reply here.
Top Bottom