losing video picture in BI using foscam camera's

O

oregonduck

n3wb
Dec 21, 2015
8
0
When I got my new Foscam camera's I got them working perfectly in Blue Iris. Then all of a sudden they have started losing the live feed in BI's window. It says "https timeout 12002". One day it took all day for them to come back on and now it randomly does it on different camera's that I have. It isn't the camera's signal because it does it on any of the camera's that are the closest cams to the computer running BI also. Also I have configured them in my Netgear router as FTP (is that correct since the timeout is HTTS:?) I'd appreciate any help at all. Thank you
 
Which model? Also, for local cams on local BI, you shouldn't need to do anything on your router.
 
Ssayer said:
Which model? Also, for local cams on local BI, you shouldn't need to do anything on your router.
Click to expand...
I have #4 F19803P wireless and #3 F19816P wireless. I needed to set them all up wirelessly with their own IP address with my Netgear Router when I got them. Also I am unable to log in to BI remotely even tho' I have port forwarded correctly :)
 
Wireless is probably your "losing the live feed". I'm down to only 2 cameras on wireless (two different brands). We lose live feed from them for whatever time our Microwave oven is on. There are a myriad of other reasons to temporarily lose the live feed.

If you've forwarded the port correctly, then BI will work. Period. Are you using the WAN IP or the LAN IP when you try to access it remotely?
 
Also, you don't need to set their IP address with your router. You can do it in the camera's configuration (that's how I've done all of my cams regardless of make/model).
 
Ssayer said:
Also, you don't need to set their IP address with your router. You can do it in the camera's configuration (that's how I've done all of my cams regardless of make/model).
Click to expand...
I am using the Wan IP address to remotely connect to Blue Iris...still not luck...thank you for all of your answers ~ it gives me a great starting point to work with. If you can think of anything else that might help me I'll gladly listen :)
 
Another possibility for not connecting to Blue Iris... what port is it on? Are any of the cams (or anything else) on that port?
 
@oregonduck In blue iris, for each camera, go to properties>video>configuration and set the receive buffer to 20mb. When a camera is down, see if you can log into it via the browser that will tell you if its the camera or BI.
As far as remote viewing, what port are you using? have you check to see if the port is open using canyouseeme.org?
 
I just found out that the new smart meter from Detroit Edison was interfering with my signal from my router . I dont know if you have a new meter but maybe that is your problem.
 
Re: losing video picture in BI using foscam camera's *** SOLVED***

So I have agonized over this for the past week. I've searched the internet to the very end trying to find out what the problem was. I think I've finally got it...

In the foscam software for each camera go to settings ~ then Network ~ then UPnP ~ make sure this is set to YES enable. However, make sure that you click on another tab and SAVE settings. Log out and your camera's should work perfectly.

I also want to give a shoutout to Mike who has created a Blue Iris Tool add on. This allows you to create a weather overlay on any camera along with other useful tools to tweak Blue Iris to your liking.
Thank you to all that has contributed to helping me with my problem...I appreciate all of your input it was very very helpful.

I will post updates if my status changes with foscam dropping video signal again in BI :cool::cool:
 
You must log in or register to reply here.
Top Bottom