Mounting the 2332 on cedar shingle

[105437]

One of my 2332s will be mounted on the side of my house on a cedar shingle. Will it be a problem that the shingle is on an angle and not perfectly vertical? Will I be able to adjust for this?

 

[fenderman]

One of my 2332s will be mounted on the side of my house on a cedar shingle. Will it be a problem that the shingle is on an angle and not perfectly vertical? Will I be able to adjust for this?

It will be fine..

 

[105437]

Thanks @fenderman... good to know I can adjust for this because a 10° camera tilt on the vertical axis would get annoying to me after a while.

 

[Del Boy]

2332 is 3-axis mount, so point it wherever you want and at the exact angle. As already said, it'll be fine.

 

[OldStyle]

Should not be an issue...

 

[LittleBrother]

Thanks @fenderman... good to know I can adjust for this because a 10° camera tilt on the vertical axis would get annoying to me after a while.

Not only can you adjust for 10 degrees, but you can for 90. I have one of those cams on an overhang parallel with the ground and another mounted on a wall perpendicular to it.

 

[105437]

@LittleBrother... good to know. In my case the perpendicular mount is on my cedar siding which has a slight angle to it as they overlap each other. Just wanted to know if I could adjust for that and it sounds like I can. If not, I was planning on cut a piece of another shingle and flipping it to allow the camera to mount on the vertical axis.

 

[MrCourtney]

See if this will do the job.
http://www.amazon.com/Arlington-8141-1-Vertical-Siding-Mounting/dp/B002W6ZOCO/ref=pd_sim_60_1?ie=UTF8&refRID=1GX9EGQS0Z96CKSECPXH