NVR DS-2CD2543G0--IS + Sony IP 335 No Motion Detection

[German_Dude]

Hello from Germany and Thank you @All Supporters for you're great Work

I'll Hope you're can Help at my Problem.
On my TRENDnet DIN-Rail 16 Port PoE+ Switch I have 8 IP PoE Cam's working (2x Hikvision DS-2CD2543G0--IS , 6x Mini IP PoE Sony 335).
They're Connectet on Hikvision NVR DS-7616NI-I2 and Live View of all Cam's are working fine.
The Problem is:
Only Motion Detection on Hikvision Cam's working and NVR would Recording.
On my 6 Birdwatching Cam's (Sony335) just Motion Detection shown as Log Entry in Alarm History directly in IP Cam.
The Hikvision NVR didn't start Recording, No Motion Detect, No Alarm, No Log Entry.

Is it a Protokoll / Configuration Problem ? What's going wrong ?
I'll Hope you're can Help

Thank you
Best Regrads from Germany

 

[alastairstevenson]

Is it a Protokoll / Configuration Problem ? What's going wrong ?

What protocol are the Sony cameras connected with?
If ONVIF, it may be that they do not generate any ONVIF motion events.
Not all cameras do - even though they may have motion detection capability.
If you can connect a PC to the same network as the cameras, you can use ONVIF Device Manager (sourceforge.net) to query the cameras and see what if any ONVIF events they generate.
Give ODM the logon credentials needed at the top left of the window.
Any events will be on the Events page, also you can see what analytics are supported on the Rules page.

 

[German_Dude]

Thank you for you're fast Replay.

This is the Motion Alarm Event shown on ODB:




The Cam is connected via Hikvision Protocol with the NVR



IP Cam (sony 335 (Type XM530_80X50_8M, Firmware V5.00.R02.00030679.10010.249b00..ONVIF 2.41) is detect any Motion but NVR isn't Recording

UPDATE: Motion Event was written in History Logfile of NVR but NOT Recorded

 

[alastairstevenson]

XM530 is I believe Xiongmaitech firmware.
While it has a 'hikserver' daemon to give a degree of Hikvision compatibility there may be some limitations on event notifications.

On the other hand - of the NVR shows events in its log, that suggests that the NVR event recording is not configured properly.

 

[German_Dude]

I don't know what to do else.
All Cam Alarm Events Settings are exactly the same. Cam 1+2 (Hikvision) working well with Motion Detection incl. Recording.
Cam 3-8 (Sony) did only Log Entry (Motion Detect) with no Recording.

Maybe a missing Parameter but on wich Site ? Hikvision or Sony ?
I don't know.
Maybe Contact Hikvision Support can Help

I didn't can change the Sony Mini Cam's because they are Perfectly for Bird watching Cages