Hello community.
I am trying to supply power to a 2032-I and a 2432F-IW camera model using a standard POE injector that simply provides permanent power on pins 4,5(+) and 7,8(-).
I was careful and current-limited it to a couple hundred milliamps using from 12V to 48V
but the cameras wont start-up and there is no power drawn from the bench supply either.
Do these cameras really uses mode B POE pinout?.
Do I need to enable something in a menue or add/remove a jumper.
Thanks in advance
-Peter
I am trying to supply power to a 2032-I and a 2432F-IW camera model using a standard POE injector that simply provides permanent power on pins 4,5(+) and 7,8(-).
I was careful and current-limited it to a couple hundred milliamps using from 12V to 48V
but the cameras wont start-up and there is no power drawn from the bench supply either.
Do these cameras really uses mode B POE pinout?.
Do I need to enable something in a menue or add/remove a jumper.
Thanks in advance
-Peter