Hi,
i just recently bought a new hikvision DS-7608NI-k2/8p nvr, due to some Problems with my old ds-7608ni-e2/8p.
With the old nvr all of my ip cams were connected without problems using the Poe ports on the nvr. But the new nvr doesn't recognise the cameras at all. No lights on the poe ports on the back of the device are flashing.
I have six hikvision IP cams. 1x DS-2CD3132-I and 5x DS-2CD2132-I, all running V5.2.0 build 140721. The new Nvr is using V3.4.104 and the old one V3.3.0.
I tried setting a strong password on the new NVR and the ip cams, but that didn't worked.
I think there is a problem with the newer NVR firmware and the old ip cam firmware. But i'm a bit concerned updating my ip cams because they are all chinese versions with CCCH serial.
Is there any way i can use the new Nvr with my old cams?
Thanks.
i just recently bought a new hikvision DS-7608NI-k2/8p nvr, due to some Problems with my old ds-7608ni-e2/8p.
With the old nvr all of my ip cams were connected without problems using the Poe ports on the nvr. But the new nvr doesn't recognise the cameras at all. No lights on the poe ports on the back of the device are flashing.
I have six hikvision IP cams. 1x DS-2CD3132-I and 5x DS-2CD2132-I, all running V5.2.0 build 140721. The new Nvr is using V3.4.104 and the old one V3.3.0.
I tried setting a strong password on the new NVR and the ip cams, but that didn't worked.
I think there is a problem with the newer NVR firmware and the old ip cam firmware. But i'm a bit concerned updating my ip cams because they are all chinese versions with CCCH serial.
Is there any way i can use the new Nvr with my old cams?
Thanks.