Re-process Motion Detection

R

rfj

Pulling my weight
Oct 26, 2014
415
123
I realized that my motion detection wasn't set properly. There was a hit-and-run on our street but nobody knows an approximate time. Since my motion detection wasn't set up properly I would have to go review the entire video (at about 8x in order to not miss anything). This would take a long time. Is there a way to reprocess recorded video and get new motion detection/alarms for those videos?
 
rfj said:
I realized that my motion detection wasn't set properly. There was a hit-and-run on our street but nobody knows an approximate time. Since my motion detection wasn't set up properly I would have to go review the entire video (at about 8x in order to not miss anything). This would take a long time. Is there a way to reprocess recorded video and get new motion detection/alarms for those videos?
Click to expand...
It can't be done with Blue Iris. If the camera caught any of the hit and run you'd be able to find the video easily by simply skipping large portions of the video until you see the damage then go back.
 
  • Like
Reactions: CanCuba
The hit and run happened down the street with the car moving towards our house (unless the car turned around). So I am looking for a damaged car passing by our house. Anyways, thanks for the response.
 
I have had to do that a few times, reviewing a night's worth of footage looking for something that drives by. I have found that 8x speed works the best. Thought that 32x or 16x would work, but it jumps a bit and can miss something go by if it is fast or the FOV is narrow.
 
  • Like
Reactions: aristobrat, fenderman and rfj
^ Cool, give it a try and report back to this thread to inform others.
 
  • Like
Reactions: djmadfx
You must log in or register to reply here.
Top Bottom