SmartPSS is using a lot of data when idle

jack7

Getting comfortable
Joined
Mar 21, 2019
Messages
323
Reaction score
250
Location
USA
Hi,

I use SmartPSS V2.003.0000004.0.R.201021 app on Windows 10 and I experience high data usage even when the program is idle with no Live View open. There is about twenty devices connected, most of them over p2p. I am sure the data are consumed by the SmartPSS. When I close the the app the data goes down.

I would expect, that there might be some data establishing the p2p tunels. But this seems to be a bit of too much.

Is this expected behaviour?

Would you guys check yours SmartPSS. Thank you. Pavel

View attachment 129613
View attachment 129614
With a short test, I don't get results similar to you.
My PC PSS has 4 cams, one is P2P. Same PSS version as you.
Task manager shows the following on Performance page for ethernet:
No PSS 0 Kbps
PSS idle 0 Kbps
PSS 2 cams liveview 6 Mbps
PSS idle 0 Kbps
No PSS 0 Kbps

Related PSS processes that could be active if enabled:
PC-NVR.exe with Challenge.exe. These would not normally turn off if PSS is turned off.
 
Top