Does anyone have any knowledge of a lock tight fitting that goes from 3/4" down to 1/2"? Or how to reduce it down? I can't find anyone where I live that has the proper connectors. I have 3/4" inlets on my one junction box plus 3/4" flexible PVC tubing but the box that I got for my corner mount, the PFA120 only has 1/2" inlets. I wish I could make the PFA120 inlets larger. The cat6 cables I'm using won't fit in that 1/2" tube without a lot of fight, if at all.
Well, after thinking about it, maybe I can make the hole larger. Do you think it would work to make the hole larger. I would not screw it in because there would not be any slots but the nipple would fit through, the rubber washer would seal it underneath and the metal nut would tighten it down. Has anyone tried this? Thanks
Well, after thinking about it, maybe I can make the hole larger. Do you think it would work to make the hole larger. I would not screw it in because there would not be any slots but the nipple would fit through, the rubber washer would seal it underneath and the metal nut would tighten it down. Has anyone tried this? Thanks