Can anyone tell me what I am doing wrong? I get a clip generated by sun/shadows activating the motion detector on a cam. I have the rectangles turned on and so I see the location in the image where the motion is taking place. I replay the clip, and select "Test Run Video Through Motion Detector" and only the areas that I have defined as Zones are visible, the rest of the screen is blacked out - I think that's normal.
Then, I changed the motion detection settings on that camera properties, even something as basic as requiring the motion to occur for 10 seconds. In theory, when replaying the clip in this mode, now with a 10 second minimum duration, I should not see any rectangles because the motion only last for a second or two, correct? I see the same exact motion rectangles as in the original clip.
Humm, maybe the clip has the rectangles recorded onto the clip since I had the rectangles originally set - so I remove the rectangles in the cam properties and return the minimum duration back to 0.7 seconds and wait for the next sun/shadow event. An hour late, it triggers motion based on sun/shadows again - this time with no rectangles visible. I change the settings of the cam back to 'show rectangles' and then replay the clip using "Test Run Video Through Motion Detector". I do not see any rectangles. Shouldn't I see rectangles to show where the motion occurred? What am I doing wrong?
Thanks in advance for your help with this feature!
Then, I changed the motion detection settings on that camera properties, even something as basic as requiring the motion to occur for 10 seconds. In theory, when replaying the clip in this mode, now with a 10 second minimum duration, I should not see any rectangles because the motion only last for a second or two, correct? I see the same exact motion rectangles as in the original clip.
Humm, maybe the clip has the rectangles recorded onto the clip since I had the rectangles originally set - so I remove the rectangles in the cam properties and return the minimum duration back to 0.7 seconds and wait for the next sun/shadow event. An hour late, it triggers motion based on sun/shadows again - this time with no rectangles visible. I change the settings of the cam back to 'show rectangles' and then replay the clip using "Test Run Video Through Motion Detector". I do not see any rectangles. Shouldn't I see rectangles to show where the motion occurred? What am I doing wrong?
Thanks in advance for your help with this feature!
