Timecode studder?

[Elo]

The feed on my Eval Version studders ... the time code jumps forward then back ... the image on the screen does the same (a vehicle will jump forward then back)

Direct View of Stream doesnt show the same issue.... nor does it studder in "Easyviewer"

Any ideas? Suggestions

Camera ipc-hdw5231r-ze


Sent from my SM-G960U using Tapatalk

 

[fenderman]

The feed on my Eval Version studders ... the time code jumps forward then back ... the image on the screen does the same (a vehicle will jump forward then back)

Direct View of Stream doesnt show the same issue.... nor does it studder in "Easyviewer"

Any ideas? Suggestions

Camera ipc-hdw5231r-ze


Sent from my SM-G960U using Tapatalk

are you using smart codec?
also could be your reencode settings, direct to disk does not work in the demo.

 

[Elo]

are you using smart codec?
also could be your reencode settings, direct to disk does not work in the demo.

Im unsure, just set it up today.. default settings with the exception of max frame rate (which is set at 30FPS) ... havent had time to mess with it

Sent from my SM-G960U using Tapatalk

 

[fenderman]

Im unsure, just set it up today.. default settings with the exception of max frame rate (which is set at 30FPS) ... havent had time to mess with it

Sent from my SM-G960U using Tapatalk

well you will have to check...see wiki on how to properly setup BI.

 

[Elo]

well you will have to check...see wiki on how to properly setup BI.

Will do, hoping it was a known issue. I'll dig deeper tomorrow

Sent from my SM-G960U using Tapatalk