I have a HikVision DS-2CD2732F-I dome camera. It used to work fine, plugged into a HikVision NVR. We were recently burgled. They pulled the cord from the camera, I've had to take it down to remount it. I've moved the NVR to another country (Don't ask). I'm trying to work with the camera.
I can't seem to communicate with it. SADP didn't see it at all, so I did a reset on the camera (Held the button in for 20 seconds on boot). Now, about 2 minutes after it boots up, SADP sees it. 192.0.0.64. All the parameters look good. So the first thing I want to do it change the camera settings to accept DHCP so that it can be on my 192.168.1.x network. I check the DHCP box, enter the default admin password of "12345", press save, but then it waits about 10 seconds before responding "Timed Out". About a minute later the camera disappears from SADP.
I've tried several times. It's almost as if the 192.0.0.64 is a clashing IP and that I can't talk to it. I don't have a complex setup. A router handing out IP addresses to about 6 devices.
Anyone seen this before?
I can't seem to communicate with it. SADP didn't see it at all, so I did a reset on the camera (Held the button in for 20 seconds on boot). Now, about 2 minutes after it boots up, SADP sees it. 192.0.0.64. All the parameters look good. So the first thing I want to do it change the camera settings to accept DHCP so that it can be on my 192.168.1.x network. I check the DHCP box, enter the default admin password of "12345", press save, but then it waits about 10 seconds before responding "Timed Out". About a minute later the camera disappears from SADP.
I've tried several times. It's almost as if the 192.0.0.64 is a clashing IP and that I can't talk to it. I don't have a complex setup. A router handing out IP addresses to about 6 devices.
Anyone seen this before?