Hello! I asked the electrician wiring my new house to install a Dahua VTO2201F-P. Ethernet cable was crimped in reverse order by mistake (funny thing, VTO was powering on anyways) and didn’t show in my network of course. Cut the cable and crimped again the connector, now it shows on my net but I’m having issues reaching the web gui.
I see the default IP 192.168.1.108 online on my router, but I still can’t ping or browse it, even in the same vlan.
If I press the call button on the VTO, it plays the calling/call ended sounds.
Any advices on this?
Thank you!
I see the default IP 192.168.1.108 online on my router, but I still can’t ping or browse it, even in the same vlan.
If I press the call button on the VTO, it plays the calling/call ended sounds.
Any advices on this?
Thank you!