Hi,
Not sure if I am doing this right, but I want my GJD PIR to trigger recording of multiple cameras off my Hikvision 7208HGHI-SH/A Turbo Hybrid - doesn't have alarm inputs, hence why I purchased a 2132F-IS IP camera with alarm input. I only have one cat5 going to the camera unfortunately,but I have used one pair of the Ethernet cable and wired them into Alarm IN and GND on the pigtail of the camera. At the other end, the pair is connected to the trigger output of the PIR, which is set to N.O.. I know this PIR is set up correctly as it was from a previous install.
1) Under Event settings, Alarm Input is set to the IP camera "xxx.xxx.xxx.xxx:8050<1"
2) Alarm Type set to "N.O."
3) "Enable Alarm Input Handling" checked
4) Scheduled all-day, every day.
5) Linked three cameras, including the camera with the alarm input
6) Under Storage settings, I have enabled recordings for the cameras that I want and set them to Alarm.
Does this sound right? Nothing is recording when the PIR is triggered, but as test I set it to N.C. and I started getting emails (set under linkage). I also tried shorting Alarm In and GND but that didn't work either. Any ideas?
Not sure if I am doing this right, but I want my GJD PIR to trigger recording of multiple cameras off my Hikvision 7208HGHI-SH/A Turbo Hybrid - doesn't have alarm inputs, hence why I purchased a 2132F-IS IP camera with alarm input. I only have one cat5 going to the camera unfortunately,but I have used one pair of the Ethernet cable and wired them into Alarm IN and GND on the pigtail of the camera. At the other end, the pair is connected to the trigger output of the PIR, which is set to N.O.. I know this PIR is set up correctly as it was from a previous install.
1) Under Event settings, Alarm Input is set to the IP camera "xxx.xxx.xxx.xxx:8050<1"
2) Alarm Type set to "N.O."
3) "Enable Alarm Input Handling" checked
4) Scheduled all-day, every day.
5) Linked three cameras, including the camera with the alarm input
6) Under Storage settings, I have enabled recordings for the cameras that I want and set them to Alarm.
Does this sound right? Nothing is recording when the PIR is triggered, but as test I set it to N.C. and I started getting emails (set under linkage). I also tried shorting Alarm In and GND but that didn't work either. Any ideas?