Has anyone had any experience with such a camera? It is a camera branded in this case as Techage 5Mpx. I have a huge problem because I installed OpenIPC and this camera is not fully supported so I would like to go back to the factory firmware, but I don't know what type of firmware I should use.
Does anyone have a memory dump or could point to the correct firmware that will allow me to restart the camera?
It has a programming terminal, I have soldering skills - I have already checked a dozen or so batches, but none of them allowed me to get the operation as it was at the beginning. Mostly I had a picture, but either discolored, or the plug on the cable did not indicate the network card was working.
I can edit the Mac address, so that won't be a problem. Please help.
![photo_2023-06-04_10-54-11.jpg](/data/attachments/164/164783-e13fa9b9b198e0f6c055e0feb31aefbd.jpg)
![photo_2023-06-04_10-54-20.jpg](/data/attachments/164/164784-3d8864e0fe1017a9a617286031322336.jpg)
Does anyone have a memory dump or could point to the correct firmware that will allow me to restart the camera?
It has a programming terminal, I have soldering skills - I have already checked a dozen or so batches, but none of them allowed me to get the operation as it was at the beginning. Mostly I had a picture, but either discolored, or the plug on the cable did not indicate the network card was working.
I can edit the Mac address, so that won't be a problem. Please help.
![photo_2023-06-04_10-54-11.jpg](/data/attachments/164/164783-e13fa9b9b198e0f6c055e0feb31aefbd.jpg)
![photo_2023-06-04_10-54-20.jpg](/data/attachments/164/164784-3d8864e0fe1017a9a617286031322336.jpg)