Hi All, I have used this forum to get to where I am now and think this is one of the best single sources of information out their for setting up an IP cam system DIY. I really appreciate this and hope to give back once I learn more. This said, and Opsec out the door, I wanted to share my current plan which I have not set-up yet but have all the hardware for. I am having someone help me run the Cat 6 cable. Here is my plan: https://i.imgur.com/ctuM7qx.jpg .
I have a few questions: since the NVR only has one ethernet port, should I connect it to the Switch which is connected directly to the router?
Will the NVR and switch be OK in the crawlspace/attic where it may reach temps in excess of 120-130 degrees in the summer or do I need to take-over a closet inside the house? The crawlspace would be much easier if it can take the heat. Is there any fire risk?
Last questioN: Should I use Cat 6e or better Cat 7 now to "future proof" while I have the installer?
Thanks in advance!
-A
I have a few questions: since the NVR only has one ethernet port, should I connect it to the Switch which is connected directly to the router?
Will the NVR and switch be OK in the crawlspace/attic where it may reach temps in excess of 120-130 degrees in the summer or do I need to take-over a closet inside the house? The crawlspace would be much easier if it can take the heat. Is there any fire risk?
Last questioN: Should I use Cat 6e or better Cat 7 now to "future proof" while I have the installer?
Thanks in advance!
-A