Please refer to thisCheck your system information and see if it says V1 or V2.
I think the initial post at the moment suggests that it is for V2 only - I had it installed on my V1 but had problems as per my older post. There's also potentially a boot loop issue with the post before yours that may be caused by applying this firmware to V1... Maybe I just got lucky.
I think we probably need some clarification from @EMPIRETECANDY Andy on this perhaps...
Sent from my ONEPLUS A5000 using Tapatalk
Where does one look to find this. All my 5216-4ks2 says for model is "NVR". On the web interface, smartPss, and hardwired monitor.Check your system information and see if it says V1 or V2.
I have a V1 as well with NVR4.0, no issues thus far but running firmware fromCheck your system information and see if it says V1 or V2.
I think the initial post at the moment suggests that it is for V2 only - I had it installed on my V1 but had problems as per my older post. There's also potentially a boot loop issue with the post before yours that may be caused by applying this firmware to V1... Maybe I just got lucky.
I think we probably need some clarification from @EMPIRETECANDY Andy on this perhaps...
Sent from my ONEPLUS A5000 using Tapatalk
Same issue happened to me. NVR reset itself to 192.168.1.108. I didn't realize there was a V1 & V2 version......Have twice now found that the NVR has reset it's static IP address on a different subnet to 192.168.1.108 from the correct address. No human intervention, not a DHCP or router issue....
View web interface (In running v4.0 firmware), go to Operation -> Information. It will then show a hardware version.
View attachment 59409
Sorry on my phone at the moment but yes, the 2019 firmware works fine for V1, there may be minor bugs. See the posts by @redfive earlier in the year who tested a few versions from memorySo I need to put on the 4.0 firmware then check for hardware version (assuming it would work because if I have 1.0 and it could break). Is there a way to check it in the 3.0 firmware before leaping?
Good to see yours is 1.0...
So looks like the 4.0 can install on v1. This is the 2019 firmware did you find the 2020 didn't work? Is 2019 the way to go for v1.0 stab?
Interesting. Bought mine from Amazon 2 weeks ago. Exact same part number as you. Front panel has Dahua name on it. Same bottom label too but no version number on my label at all. Web interface agrees with yours - mine says hardware is V1.0. Your web interface says the Device Model is just "NVR". My web interface says "DHI-NVR5216-16P-4KS2E". My firmware is currently on the 2019-12-06 version. I had upgraded the firmware the day I got it. I don't recall the prior version number.Hardware version question too. Bought my NVR 5216-16P-4KS2E from Andy last July. The date on the shipping box states 2019-06
The label on the bottom of the actual NVR has "V2.00 next to the P/N. The NVR's web interface states hardware version V1.0
Direct logon to the NVR states hardware version V1.0 So what is the actual version?
Can you ‘Live View’ from web on both versions? I get a download certificate message. Live view still works from smartpss.I have upgraded tens V2 and tens V1 versions with V4.001.0000000.1.R.200319, no issues so far, cant understand the fuss.