Synchronize Timing.?

C

critterles

Young grasshopper
Jan 31, 2015
47
1
I have cams the pan to a preset every 10 minutes and also upload a snapshot every 10 minutes. Is there any way to synchronize these to actions ?
Not being in sync can make the image wait up to 19 minutes before changes are visible.

Thanks for any suggestions.
 
Run this utility on your Blue Iris server...

http://www.timesynctool.com/

Then set each camera's firmware to use your Blue Iris Server as their NTP (Network Time Protocol) server.

I do this and all 22 of my cameras are time-synced to within a second or two.

Problem solved!
 
This sounds great, I was just hoping someone would respond to this post. Not sure I've seen this option on my Foscam cams. I'll have to check it out. Also does the timesync tool run as service and auto load?
 
critterles said:
This sounds great, I was just hoping someone would respond to this post. Not sure I've seen this option on my Foscam cams. I'll have to check it out. Also does the timesync tool run as service and auto load?
Click to expand...
I think you are both discussing distinct issues. If I understand correctly, Crit, is trying to sync the pan every 10 minuets with the snapshot every 10, so that basically a snapshot is taken every time the camera pans.
Q is discussing a timeserver that can sync your cameras clocks...
 
critterles said:
...does the timesync tool run as service and auto load?
Click to expand...

Yes, this utility runs as a Windows service which is labeled "NetTime."

critterles said:
...Not sure I've seen this option on my Foscam cams...
Click to expand...

I run Vivotech, Hikvision, Dahua and ACTi cameras critterles and all of these brands allow the user to specify an NTP timer server for their cameras...so I would expect that Foscam also has such a setting.
 
OK, Q2U, Does that mean your solution won't accomplish what I was trying to do? It would be nice if you could set the Pan and the image upload to a set time.

I'm new with Blue Iris so bear with me. If I set up a profile to run the cams starting at 9:00am. and turn off at 6:00pm.
Would all the timed settings start at the same time and therefore follow the same cycle all day long. Each morningthey would get kind of a reset.

??
 
Just found the Foscam setting, thanks so much.

I have been on a lot of forums over the years and I have to say I like this one. Lots of help for people with puzzles to figure out.
 
You must log in or register to reply here.
Top Bottom