Recent content by acd333

Thanks I'll try it. Looks like the Noctua NF-A4x10 5V 3pin version should be a direct replacement.

Hello, My case fan (AD0405MX-G70) is getting very noisy. I can take it out and spin it with compressed air and it is quiet. I'm guessing it must be the motor itself. Has anyone found a good replacement for these fans? Thanks

Yeah, I tried even running just one camera off of the NVR with no luck. Swapped the power supply as well. Only POE issue out of the 4 Dahua NVRs I have.

If anyone else runs into this issue, I did manage to get the time I needed to record: 1 - If playing back on DMSS app, I could start the playback before the inaccessible time and it would continue to play. 2 - Once it reached the part I needed to record, I just hit the record button (looks like...

Missed your second question, the PoE ports on this NVR never worked out of the box, so I am using a couple of external switches.

PC. If I play it on my phone, I can't select the correct time stamp, but I can start it playing before the "buggy" time and it will play through. Camera time must be out of sync with system time or something like that.

Hi, Yes, I switched to SmartPSS because I needed to log in remotely. We tried first on the phone app, then on the web app, all with the same results. It seems to be all the cameras (8 of them) and all times of day where this issue is occurring.

Hello, I am attempting to download some footage from a camera using SmartPSS software. The software shows the footage is available (all green) but when I play it back (or try to record) the following happens: I can play from 00:43:00 until approximately 00:48:00. After this point the footage...

Okay I think I have it fixed. I did a Factory Default on both the cameras and IVS is now working after reboot. It wasn't an issue with IVS, it was that none of the settings would save after a reboot of the camera.

Looks like it is the camera. I have an identical camera on the other side of my building and I duplicated the issue on it. Another camera I have works just fine. I will try updating firmware.

My firmware on the NVR says up to date: System Version:3.215.0000000.3Build Date:2017-12-11 Camera firmware is: 2.460.0000.15.R, Build Date: 2017-09-07 I have motion detection enabled, and it persists across reboots. I just tried something: 1 - Set up IVS on camera, verify it shows up on NVR...

I get the same result whether I set it up on the NVR or the camera interface. I can see the trip wire on the NVR preview of the stream, but it all disappears after reboot. Nothing persists in the IVS settings on the camera or NVR.

Hello, I've had my NVR/cameras for a number of years now and finally getting around to playing with the IVS feature. Until now I had motion detection recording set up with no issues. NVR is a 16 channel Dahua, NVR-5216-16P-4KS2, with the old web interface. Camera is IPC-HDW5231R-Z. I have...

Thanks everyone for your help. I managed to access the cameras through the Netgear PoE switch so we could position them before our scissor lift was returned. Great service as always from Andy, quick to respond and get a solution.

Okay thanks, any special setup to do things that way? I imagine I'll have to individually access each camera to set the IPs?