Recent content by alekslyse

As I have a UDM Pro already it has the NVR built in. I have the non pro version and some other cameras I expose over rtsp to my surveilance systems with no issues. Wish it could be in standalone, but it works well since I have the NVR there anyways. Btw they usually have three streams of...

Network config is Unifi Pro with 10GB SPF backbone powering over POE directly from a rack switch. For now the cameras is on an open, unrestricted VLAN (tried without VLAN too with same result). I have two consumers of the cameras. 1. Synology Surveilance station that consume the main stream 2...

Here is an example of the skipping.

Oh sorry, you said Next get rid of CBR so I assumed VBR, but I changed them to CBR now. (only two options). It helped a BIT on the smearing (the artefacts), but still I see it skips seconds on the main stream. Since this is happening in the UI of the camera I assume we can rule out the cables...

Thank you for your input. I have now for starter changed CBR to VBR on the 3 cameras and 4096, set exposure to manual and the range you suggested. The gain is now 0-40. Regarding the Backlight is all set to off

Maybe this helps: i just say again so no confusion this is 100% default settings and all ‘ai’ things like motion detectors etc is turned off so should not be affecting the cpu

I have the old HDW5231R-Z 2MP that has been serving me well running on a unifi setup. I have newer dahua cameras that don’t behave like this. I have been updating the firmware on those with never any issues and today i factory reset them just to be sure. main stream is 264, 10fps, 1080 even...

Does anyone know about a battery / solar powered (can be poe) with light fast conntection, 4k, and good ir? I need a low profile 100% local camera for face recognizion on the fromt door. Cant install onvif doorbells as they pull over our transformators and getting expensive. Its snapshots will...

I downgraded to 15 and problem gone for now

I can report the same issue on 16 - substream 1 reset and substream 2 reset / disabled. A huge problem for AI / face / object detection that should not use main stream

This is on IPC-HDW5231R-Z with V2.800.0000016.0.R - From what I remember that was the firmware they should run? Is it a firmware that is known to be better?

Have anyone experienced things like sub streams reset, night mode color changes with no interaction? I have started to experience syubstrean 1 reset to 264h and substream 2 turns off. The consumer is using the streams over ffmpeg so no onvif

I installed yesterday a SD1A203T-GN that I should use in a terrarium - with its IP grade that should be no issue, but after being running for 5-6 hours this happened. The camera is in a temperature of around 30c and no water or moist close to it. Any solutions to this. I never openened it or put...

Going to have terrarium cameras Requirements: smallest possible size ptz onvif (going to use in synology surveilance) non cloud possibility waterproof a bit zoom will be used for terrarium so important wide view in a small space

I also did see someone tried to add it to Home Assistant, but never got merged Add reboot command to onvif camera component by KoljaWindeler · Pull Request #29069 · home-assistant/core - if it works with the home assistant onvif library its easy to write a custom service that does this kind of...