Recent content by dahuauser

Opened the camera and next to the lens there was a small circuit board with a small reset button on it, held down for 20 seconds until the green LED went out and the camera was reset.

Found the reset button, was able to reset, camera works, problem solved.

Hello, I have already opened the camera, I do not immediately see a reset button there either.

Attached photo of the camera, no SD card slot available

Hello, this camera does not have an SD card, attached photo of the camera's identification sticker

Hello, I own 2 cameras Osiris OS-I2-EEN5M that I would like to reset to use with a Dahua recorder, anyone know where I can find the reset button?

Thanks for the explanation, this is what Jarrow also communicated to me.

Have a recorder with 8 channels to which a number of cameras are connected via POE, so utp cable. I still have some older cameras that I would like to connect to this recorder, is this possible? and if yes, what do I need for this? Attached photo of type of camera and recorder.

Ok bedankt, als ik de website open, komt die bij mij in het nederlands.

Heb een recorder met 8 kanalen waarop een aantal camera's zijn aangesloten via POE dus utp kabel. Heb je nog enkele oudere camera's liggen die ik zou willen aansluiten op deze recorder, kan dit? en indien ja, wat heb ik hiervoor nodig? In bijlage foto van type camera en recorder.

Nobody? I opened the camera and reset it, no change.

Heb een IPC-HDW1531S die van de ene dag op de andere niet meer overschakelt van nachtmodus (zwart/wit) naar dagmodus (kleur) wanneer ik hem opnieuw connecteer dan start hij terug op in dagmodus (kleur) wanneer het donker wordt gaat hij in nachtmodus (zwart/wit) maar de volgende dag blijft hij op...

I went to a dahua specialist with my recorder, he reset my recorder, I don't know how this happened, there is indeed not much to be found on the net, and those who can keep it apparently secret.

Doesn't help, tried several times, there is there still a battery on the other motherboard, is this battery soldered to cause the problem?

Am back, took a closer look at the contents of my recorder and there is a 2nd motherboard on which the utp connections are and I do find a J1 there, see photo, so try to reset there? and should the cameras be connected or not, have they also been given a password with the NVR?