Recent content by Ihbond

finally got the cameras, cables, system setup..I will post some pictures later I still have some\lots tweaking to do Seriously , thanks for guidance and support on this forum.

hi there; I would like to take a ptz and make it available to the public, using a sub stream if possible....I would like to block out some of the areas (for privacy) My intent is let the rancher in back use it for his cattle, and provide a scenic camera to the public.. Any help\configuration...

FWIW. I have ordered from Andy with no regrets and issues, so have others

I agree , love the Simpson VOM’s. // still accurate for what I use them for..

I was comparing the model I mentioned above with DAHUA. and did see a F-Stop difference (in favor of dahua) on the newer model. tempting to look into that camera, but I have to wait and see if the SD1A203T-GN makes more sense ...

so I updated this AM, camera did not get a signal (cameras already on h.265). So , I turned off hardware acceleration for h.264 restarted Blue Iris, and it worked (thanks fenderman). What I am not sure about is, I turned back on the h.264 acceleration then restarted BI and my cameras still work...

Wow that is creepy man..

Very cool, thanks. It’s a great start..

interesting, I was looking at this model earlier IPC314SR-DVPF28(36) any possibility you can send me that reps info via PM ?

The reflective glasses that could make criminals 'invisible' to security cameras | Daily Mail Online I was looking at IR devices and stumbled across these.. Just thought I would share for the heck of it..

Sure did...thanks for the reminder

Thanks..think I will run another cable to the Poe like suggested and run no\nc to the device... Appreciate the help... Just got done running the wires for all my cameras, now just need to create 8p8c ends

well, so much for thinking I their would be DC power froom those camera wires. Sounds like either I need to 1) Run a POE splitter (20 feet) off camera via rj45 and then out to 2 pir's. Then the Pir's no\nc back to camera 2) Run long cable poe (50 feet) (rj45) wire to the 2 pirs and then the PIR...

Red alarm 1 in Brown alarm in 2 in Yellow\green alarm ground 23w with IR \ 13 w no ir Bosch PIR 10 VDC to 15 VDC at 22 mA standby. V7 Poe 30w So I am new and trying to figure this out ahead of time.. So , have not metered above wires yet..but I am assuming that I can take a parallel 2 wires...

What did you ever find out on your questions ?