Ok so at around 9:30am I killed the Night schedule and set all the cams to the same profile all recording continuous + trigger.
So far as of now 8:51 pm they are all on and recording. Seems like I have crack the code as to how to mix the a Dual schedule setup. I'm sure the developers put it...
Well that was a dud... starting to wonder if it can be even done so I am going to scrap the schedules and try to have the system continuously record....
The question came up the cam are on the latest firmware.
So I just applied the setting to all the camera on the Night profile one by one.
I also earlier made sure every camera was pointed to the correct port, and set all of them to use RTSP H.64 with a trigger on ONVIF events.
I'll have to see the results in the AM.
Thanks
I have large gaps where the schedule for Night is told to start at 10 pm
10:00pm
10:45pm
No activity from all cams
10:45pm
11:39pm
only 2 out of 9 show activity
11:39pm
5:30am
No activity from all cams
5:30am
5:45am
only 2 out of 9 show activity - same cams as row 2
5:45am...
Wow just checked to verify that all the cam were just straight up recording and All of them (with the exception of a single wifi Amcrest I have in the house) say no signal from the start of the profile.
The only changes I made was from "Continuous" to Continuous + Triggered" and Setting the...
I installed a few systems a few years back using BI 4, so I have some experience with the software but those systems are Motions Trigger only. The system in my home is a BI 5 system and while for the most part they work fine, I find that I need to set the system to perform continuous recording...
While I did explain it up in a further post I'll explain it again. I'm in charge of a very large sprawling network and in order for me to keep track of the equipment efficiently it makes more sense for me to statically address my devices than relying on DHCP and then having the search through a...
" noticed in your second PIC, the gateway is not the same third octet as your static IP. Could that be it? Did you try 10.0.3.1 for the gateway?"
Yes, just to test your theory and is results in "failed" message
You will also notice in the 1st pic that the same condition exists: DHCP assigned...
You mean this right?
Yup that is the software I tried,
I maintain a rather large network and I'm old school, so I don't whip out my phone and look for cheesy app to do real work.
Reolink may not be the best of the best but they do fine with me (till something like this pops up) and...
Your talking about the Windows App. I did install it but found it be clunky and found no real way to interface with the individual camera other then putting in the password for each camera just so it would display in the App. I may have missed but I found no way to change IP setting via the...
How would I do that? The "software" is present as an OS in the camera itself, there is no option to downgrade. How does sending it back resolve the problem. I like the products they are a decent budget solution. But not pushing a vendor to properly support their product hurts the current and...