bitrate

Hi everyone! A while back I installed a Hikvision two-wire door station, modelnumber DS-KD8003-IME2. The video quality of the live stream, which is in 1920x1080, isn't great tho. In order to get better video quality, I wanted to change the max. bitrate. The manual says that the max. bitrate is...

Hey can someone tell me the best settings for ip cameras. I recently searched online but it is not working for me. The video is lagging a lot and is buffering. Ex- when a car goes by it just freezes es. I have done the following settings (photo attached). My internet speed is 250mbps. Please help!

I have several Hikvision cameras including a DS-2CD3145F which has a video resolution of 2560x1440. No matter what settings I use the bit rate never seems to go over 1Mbits. That is even when I set it to Main Stream, 2560x1440, constant bit rate @ 8192kbps, H.264. Main Profile and I Frame...

Currently I’m testing Dahua IPC-HFW7842H-Z. Hopefully the review will be ready soon, but there is still plenty to do, and I have to find time to put all material together. Anyway, while testing the camera, I’ve found something I was thinking about since my first Dahua I bought. That is, how to...

I have tried searching on the forums but couldn’t find an answer. Is direct to disk recording limited to the 8kbps that the streaming is, or is that only for re encoded video? I was wondering if I set my bit rate to the highest in the web interface for the camera will it record at that bitrate...

I can't find any info on this problem so here goes. I have my two hikvision cameras connected to my hikvision 7608-ni-i2 NVR via Poe . When I've set the substream from its default bitrate of 128kbps to 1024kbps it resets back to the lower bitrate when I view the feed on my galaxy note 9 via hik...

Hello all, I'm looking to improve the framerate in my MJPEG streams. I get around 30fps average on my cameras in both the web interface and the blue iris software on my PC. However when I access the MJPEG stream I'm getting closer to 10FPS, it's pretty choppy. I've tried messing with the bitrate...

How are folks tuning your cams for those wonderful night plate captures? I've been twiddling with a HDW5231R-ZE as an upgrade to an older non-Dahua camera for about a week. Daytime images are good, but night and twilight are problematic. Below are the settings I've tried, but I've yet to get a...

I would like to lower the bitrate that Blue Iris records at without altering the FPS. I am aware this will reduce the quality of the video. However the "Max Rate" setting in Blue Iris appears to affect both the bitrate AND the FPS. How do I lower the bitrate while keeping the FPS at 30? I am...

According to this article (reference below), most of the NVR systems sold deceptively report that they record a 1080P when this is not true for all cameras connected to the NVR at the SAME TIME. Which NVR models are truly 1080P recording of all cameras connected please? Why a NVR's bitrate is...

Hi I have six Hikvision cameras. Five DS-2CD2332-I type and one DS-2CD2032-I. All of them have version 5.2.5 firmware. My NVR is a Hikvision DS-7608NI-SE/P 4 (firmware 3.10 - latest) and each cam is connected to a Netgear POE Switch. The above run well except.... This bit is driving me...

New Hikvision NVR - Poor performance - SOLVED Hi all! First post outside of my introduction. Been reading for about a month now. I already have a Y-Cam camera but wanted to step it up.. I just received a Hikvision 7608 NI SE 8P with a 1 TB drive installed. I bought it from B&H Photo since that...

I can't seem to get the bitrate up on this CAM. What am I doing wrong?