Ok, party people, there was a micro coaxial cable on the sd6alafn-hni!!! I found a connector on the main board with the sd slot, and another on the interface board on the back of the camera. I connected them and all of the other connections, closed it up, crossed my fingers, and put power to it. Nothing. Not a hum, not a startup mode, and then the undeniable smell of dreams being crushed by something electric burning. I believe I put one end of that micro coax upside down and shorted 3 pins in the middle of it. I checked and 1 end fell out of its connection and really didn’t want to stay in. I tested it again, temporarily taping the ends of the little micros and the power came on and it started up. I went ahead and held the reset button just in case, and after a a minute, it came up with the default ip address. AND I HAD A PICTURE where I previously had the error message!!! Unfortunately the hue, saturation, and color are bad no matter how I adjust them, the exposure, contrast, brightness...all of it. It wants to be mostly red, mostly blue, or mostly green, with no good in between. Any thoughts? It is also possible that I had that micro coaxial in correctly but my polarity reversed on the power supply