have you checked the AI parameters on the NVR?
As previously mentioned I have seen where the NVR and camera don’t synch. Possible the NVR is doing the alerting and the camera is fine
Important to clear the rules completely on both. Start from scratch by clearing the AI on the NVR and the camera. Not just turning off, actually delete/remove the rules in both. Use IE.
Then test and if all well use ONLY the camera UI. Never hit save or refresh on the NVR upon viewing the rule.
Hey Bigred! Brother you may have just helped me figure this out. I don't set IVS on the NVR, is that what you mean by the NVR doing the alerting?
I have smartplan and IVS is set up on the Color-4K-X.
Anyway, I went into the NVR to check IVS for channel 15 (the asshole camera in question) and noticed IVS was checked there. How that happened, I do not know. I unchecked it so now I'll wait to see what happens.
I have smartplan and IVS on both NVR and camera now disabled. I am going to see if alerts are still generated in the NVR.
Next, if no alerts are generated in the NVR, I am going to activate IVS on camera.
Been checking it and I dont see any alerts in the NVR yet so we'll see.