DMSS and no notifications

How do I test to see if the IVS alerts are being recorded? Can I do this with the NVR or do I need to add a SD card in and then test (make movement in front of the camera) and then review on the SD card?
 
Best way is an SD card, but the next best way is from the camera GUI, turn on the IVS rules in the live view and have someone walk around and see if one of the blue lines turns red. If it turns red it is triggering. If it stays blue, then it is not triggering.
 
  • Like
Reactions: JDreaming and FLGator
The NVR has to be set to record them…

Read posts #1 and 2

***PSA for those with a New DAHUA NVR with Built-in PoE switch

IF you have a Dahua NVR with built-in PoE switch... DO NOT follow instructions telling you to use the config tool or switch the IP of your cameras or initialize anything..! With NVR's typically with a -P designation (Built-n PoE switch - example: 4208-8P-4KS2) none of that is required and it...
ipcamtalk.com ipcamtalk.com
 
  • Like
Reactions: JDreaming
wittaj said:
Best way is an SD card, but the next best way is from the camera GUI, turn on the IVS rules in the live view and have someone walk around and see if one of the blue lines turns red. If it turns red it is triggering. If it stays blue, then it is not triggering.
Click to expand...
Testing that now
 
  • Like
Reactions: looney2ns
If I recall there’s a box that has to be checked on the NVR to allow alerts through to P2P.. give me a few minutes, balancing a bourbon and a kielbasa at the moment..
 
  • Haha
Reactions: JDreaming and FLGator
Once we get IVS recording on the NVR, which is whats going to send the push notifications, then make sure this is checked

enable-push-notifications.jpg
 
  • Like
Reactions: JDreaming and FLGator
wittaj said:
That is the way it should be. By default the NVR puts the cameras on the 10.0.0.x subnet.

DO NOT CHANGE THE CAMERAS TO THE SAME IP ADDRESS OF THE NVR - that will create way too many issues. Almost everyone here has it working successfully with the cams on the default 10.0.0.x subnet, so the issue is something else.

Is your NVR on the same IP address subnet as your LAN?

Are you able to see the NVR when not on home wifi?

The issue could maybe be the P2P server is down as well.
Click to expand...
 
The mobile push notifications is on. I just unplugged the NVR for 30 seconds and plugged back in. I cannot find the setting to enable the IVS rule in the Live view to show if the color changes when a motion is made.
 
Shows offline for me too. Ok, so what is the best solution to overcome this. I do not want to be at the mercy of a system that may have issues like this.
 
You must log in or register to reply here.
Top Bottom