Footage jumping and missing several seconds on HikVision cams

Defcon

Getting the hang of it
Joined
Sep 9, 2015
Messages
133
Reaction score
26
Location
UK
How are these switches connected back to the NVR? Is one switch connected to the other and then one cable back to the NVR LAN port?
 

Nelle

n3wb
Joined
Aug 1, 2020
Messages
16
Reaction score
3
Location
uk
How are these switches connected back to the NVR? Is one switch connected to the other and then one cable back to the NVR LAN port?
Each switch is seperately hard wired to a wireless link which is then has a single cable back to the NVR
 

Defcon

Getting the hang of it
Joined
Sep 9, 2015
Messages
133
Reaction score
26
Location
UK
You could disconnect all cameras except one and see how it responds before switching another one on, one at a time till problems occur again. There is a chance maybe the Wi-fi power output link is too high and needs lowered.

There is another switch at the Wi-fi link for the two Poe switches to connect to? What is it?
 
Last edited:

Nelle

n3wb
Joined
Aug 1, 2020
Messages
16
Reaction score
3
Location
uk
Hi
I've had my system remotely connected to this morning and it's looking like the nanobeam has a problem and can only works on 10Mbps instead of higher. When the settings on the nanobeam are changed to above 10MBPS the system crashes
Being sent new nanobeams, hopefully this will sort the problem out at long last.
 
Top