Help me fine tune setting up spotter cams for my SD4A425DB-HNY mini-PTZ

[wittaj]

On a side note, my IVS tripwire for the spotter is triggering in both directions even though it is only set to B>A

Make sure that MD or SMD isn't also turned on in the spotter cam.

 

[Ri22o]

Make sure that MD or SMD isn't also turned on in the spotter cam.

Both off.

When looking at the event captures, it is clearly an IVS trigger but it doesn't matter which way the person is going.

 

[wittaj]

I guess try to delete and re-add

Post some screenshots - there might be another check box or something in this new GUI that is messing it up?

 

[Ri22o]

Spotter is on the old GUI.

I will do my best with screenshots as I navigate around it, I am sure I will miss something that could be important.

These are really the only things I see that can be relevant with the PTZ.

 

[wittaj]

Oh OK I was thinking it was the new GUI for IVS.

I meant the screenshot from the IVS rules

Did you do a zig zag? If so that is why as the zig zag makes it go both directions.

To do one direction it can only be one straight line, so then you need several IVS rules if you want a few points that could trigger.

 

[Ri22o]

Oh OK I was thinking it was the new GUI for IVS.

I meant the screenshot from the IVS rules

Did you do a zig zag? If so that is why as the zig zag makes it go both directions.

To do one direction it can only be one straight line, so then you need several IVS rules if you want a few points that could trigger.

Ok, that's the issue then. I did a zigzag to cover the area as much as possible.

I did notice it was very confusing on which way was A>B and B>A because it always seemed to be the same.