I bought a couple of cheap Wanscam HW0026 camera's to use inside to monitor my dog when we are not home, the camera's work flawlessly and the night vision is surprisingly good. Using TinyCam Monitor and Onvif Monitor the stream is perfect. The only issue is when I add them to my Hikvision NVR using ONVIF the stream as viewed in the NVR will work fine for 2-3 days then suddenly will start to flick on and then off, with more off then on, say 5 seconds of video and then off again for a minute and then on again for 5 secs and this repeats until I remove the camera from the config and add it back again and then the process repeats -
2-3 days perfect followed by 5 secs of video every 1-2 minutes. In this time the video via TinyCam or Onvif is uninterrupted so their is nothing wrong with the stream coming from the Camera. Reboots of the camera don't change the outcome. Of course all my Hikvision camera feeds are fine. When I bought them I didn't expect them to work with Hikvision but when they did start to work I got excited so I'm hoping someone might have an idea that could help.
NVR firmware is V3.4.92 Build 170228
ONVIF Device Manager reports the ONVIF version of the camera as 2.04
2-3 days perfect followed by 5 secs of video every 1-2 minutes. In this time the video via TinyCam or Onvif is uninterrupted so their is nothing wrong with the stream coming from the Camera. Reboots of the camera don't change the outcome. Of course all my Hikvision camera feeds are fine. When I bought them I didn't expect them to work with Hikvision but when they did start to work I got excited so I'm hoping someone might have an idea that could help.
NVR firmware is V3.4.92 Build 170228
ONVIF Device Manager reports the ONVIF version of the camera as 2.04