I broke BI !!?! camera stop working

Opening port 80...
HTTP Get / request...
OK
ONVIF GetSystemDateAndTime
2017-06-13T03:04:22.000Z
Requesting device information...
Manufacturer: oem
Model: xseries
FirmwareVersion: 00.01.01.0040

GetCapabilities...
Bad response
Checking for common cameras...
Foscam FI86xx/98xx compatible?
Foscam FI89xx compatible?
Foscam FI9821 V2 compatible?
Foscam FI9821 media port compatible?
RTSP port open?
RTSP port detected!
Done
Capture55.PNG Capture56.PNG
 
its deleted.....re adding got ip user and password....should i do the find/inspect? or dropdown?
 
I really think Something happened with either BI or windows 10 update....I blamed it on camera so a replaced it with same oem.....same problem....camera been working for several several months without issues
 
Killer Kool said:
I really think Something happened with either BI or windows 10 update....I blamed it on camera so a replaced it with same oem.....same problem....camera been working for several several months without issues
Click to expand...
install an older update...search forum for file..
or email support...
if you follow the directions in that thread you can easily make it work...this is why you should stick with a name brand camera if you dont want to mess around.
 
fenderman said:
see sticky in trouble shoot section on adding cams that are not listed...try suggestions..you are doing something wrong...
Click to expand...
okay I will try again and go thru sticky......I Agree that i must be doing something wrong but have not got it figured out-seems easy - this is probably my 50th camera add
 
Out of curiosity, did you check your registry and verify that you do not have two entries with the same name? This issue wrecked havoc on me after I deleted a camera, physically changed the camera out, and added the new one in BI with the same name. For whatever reason, the BI software deleted it but the registry information stayed the same.

Also, and I know this sounds simple, but your second camera Video Config screenshot showed a blank Video Path. Something to look into.....
 
Okay so Ken w/BI got the camera working......Whoop whoop...... H.264 HW decode:NO......then on network options UNCHECKED -USE rtp/udp PORTS: and Use RTSP/stream timecode ,Decode compatibility mode,Get events with PullPointSubscription....

Ken also set it to make:Generic and Model: RTSP H.264/H.265/MJPG/MPEG4
 
  • Like
Reactions: cage771
You must log in or register to reply here.
Top Bottom