Hi
Hope someone can help as this is driving me nuts.
I am in Australia and ordered my HIKvision NVR and cameras from China.
Everything has been good for a few months. I then wrote to HIKVision to ask which firmware update to use.
The NVR I have is the DS-7608N-E2 / 8P
The firmware they told me to apply was from the overseas site and was Baseline Firmware_NVR (76/77/86NI-E)_En_V3.3.1_build150422(new)
This seemed to be in English. When I updated it all was fine and it worked for a week until I rebooted it.
Now the web page is in Chinese however the IVMSsoftware is in English.
When I try and use the IVMS it says language mismatch.
I have found a tool on these forums called HIKtools05R1.exe and tried that however the language was already set to 1.
If I try the firmware from the webconsole it now says Failure to obtain the upgrade progress.
Is anyone able to help?
Thanks
Aron
Hope someone can help as this is driving me nuts.
I am in Australia and ordered my HIKvision NVR and cameras from China.
Everything has been good for a few months. I then wrote to HIKVision to ask which firmware update to use.
The NVR I have is the DS-7608N-E2 / 8P
The firmware they told me to apply was from the overseas site and was Baseline Firmware_NVR (76/77/86NI-E)_En_V3.3.1_build150422(new)
This seemed to be in English. When I updated it all was fine and it worked for a week until I rebooted it.
Now the web page is in Chinese however the IVMSsoftware is in English.
When I try and use the IVMS it says language mismatch.
I have found a tool on these forums called HIKtools05R1.exe and tried that however the language was already set to 1.
If I try the firmware from the webconsole it now says Failure to obtain the upgrade progress.
Is anyone able to help?
Thanks
Aron