I have put a couple of these into a test environment, and I believe I have them set up correctly. However, I cannot get either to trigger the motion detection email. The selector is set to enable, the active time is always.
The test email does work (received) but it doesn't ever seem like motion is detected and nothing is ever sent. I drew the square box over where I was expecting to capture motion.
Questions:
Is some sort of NVR required? I just have the cameras, and I was under the impression that the cameras could send snapshots on their own.
Video quality is excellent, but was hoping to use this feature. Any input would be appreciated, or a place to look to start.
Firmware is 5.2.0 150126
The test email does work (received) but it doesn't ever seem like motion is detected and nothing is ever sent. I drew the square box over where I was expecting to capture motion.
Questions:
Is some sort of NVR required? I just have the cameras, and I was under the impression that the cameras could send snapshots on their own.
Video quality is excellent, but was hoping to use this feature. Any input would be appreciated, or a place to look to start.
Firmware is 5.2.0 150126