Wow got it working with Dahua Firmware
i set my pc static ip to 192.0.0.128
i set my nvr static ip to 192.0.0.64
i had my NVR on DHCP before, so gonna try again
Antivirus disabled
Firewall now off
ok so i tried this firmware
DH_NVR5XXX-4KS2_MultiLang_NP_V4.000.0000000.1.R.20190809.zip
and it bricked the NVR, i wasn't worried because it was useless anyways, i restarted twice but still nothing
so i tried this firmware
and WOW, now i have Dahua on my once Dead Lorex NVR
Thanks a lot everyone for your help and guidance
this is what i did
1) set my PC ip settings to
ipv4 192.0.0.128
sub mask 255.255.255.0
gateway 192.0.0.1
2) then i used and run as admin Tftpd64 Server by Ph. Jounin
3) extracted all the firmware files in C:\Program Files\Tftpd64 folder
changed the Server interfaces to 192.0.0.128, just leave it open changed nothing
4)open NCOM v1.02
Hit *** before the countdown ends
typed: printenv
and hit enter
setenv bootdelay 9
enter
saveenv
enter
setenv serverip 192.0.0.128
enter
setenv ipaddr 192.0.0.64
enter
setenv gatewayip 255.255.255.0
enter
setenv netmask 192.0.0.1
enter
saveenv
enter
type: reset
hit enter
Hit *** before the countdown ends
type: run up
hit enter
then the Magic happens
You guys are Geniuses
Special Thanks to original post
Lorex
MixManSC
TheDude
Coachtech
then i bricked it again by updating it via webui with
DH_NVR5XXX-4KS2_MultiLang_NP_V4.000.0000000.1.R.20190809.zip, so i tried installing oldDH_NVR5XXX-4KS2_Eng_V3.215.0000000.3.R.20171211.zip but was getting error
hisilicon # run up stmmac_init,692,0x70431,3 miiphy_speed,366,1040 miiphy_speed,366,1040 ARP Retry count exceeded; starting again do_tftp_secure failed
still boot stuck at logo
did some google search then tried this from these 2 original post
Hi, try to pusch * key during the boot, you must have prompt. After you can follow my instruction.
ipcamtalk.com
Thanks to
Austrum
NVR5464-KS2 проблемма после обновления.
Thanks
Technical support VidiMost.com Specialist
so i download this update.img file and walla... my nvr was back and running
add this file to
TFTP dir then type in NCOM
so i was unable to ping my NVR so i used my last known ip in the terminal and configured my PC in the same ip range
setenv ipaddr 192.168.1.128
setenv serverip 192.168.1.108
setenv gatewayip 255.255.255.0
setenv netmask 192.168.1.1
saveenv
reset
run up
then updated firmware againg via webui with this file
