I would like some advice/help choosing settings for motion detection in Blue Iris. The area I would like to use motion detection on has been marked as a hot spot, but for some reason it will not trigger the recording. Can someone please have a look at my settings and tell me what I'm doing wrong?
These are the Motion/Trigger settings for the camera:

The area I would like to monitor has been marked with a hotspot rectangle

This is a video showing me walking in the hotspot area, and yes it's a Cat 5e cable in my hand after I had to use LAN instead of WLAN because of weak signal to the cam used to monitor the hotspot area..
[video=vimeo;95339965]https://vimeo.com/95339965[/video]
These are the Motion/Trigger settings for the camera:

The area I would like to monitor has been marked with a hotspot rectangle

This is a video showing me walking in the hotspot area, and yes it's a Cat 5e cable in my hand after I had to use LAN instead of WLAN because of weak signal to the cam used to monitor the hotspot area..
[video=vimeo;95339965]https://vimeo.com/95339965[/video]